Hoop skirt finished

It’s done! My new elliptical 1860’s hoop skirt. Some info:

Pattern: Truly Victorian 103

Fabric: White cotton

Notions: Loads of bias-tape for the bone casing, white tapes for the vertical support, 11mm steel hoop boning, 8 end-caps for the half-circle hoops and heat shrink to clasp the bones together.

The hoop is not entirely even, but close enough that it doesn’t matter with a petticoat over it. It is also similar enough to my previous hoop skirt to still fit with the petticoat and skirt I made before. It feels a lot sturdier than my previous hoop, and I’m very happy with it. I’m making my previous elliptical hoop into a 1850’s round hoop, but progress on that will follow later.

IMG_0677

 

The side view. Here it’s still knotted together at the waist, but by this point I’ve a clasp in place to reduce the bulk a bit. The tapes holding the half-hoops together behind the bum and legs also don’t work quite as well on the mannequin as on me, as it doesn’t have legs. The ‘gap’ between hoop four and five isn’t as obvious when I’m wearing it.

 

 

IMG_0678

 

A close-up of the half-wiring at the back.

 

 

IMG_0679

 

 

Another perspective.

 

 

IMG_0680

 

And the back view.

 

IMG_0683

With petticoat and skirt. The skirt is slightly long on the sides, but I’m confident that will be less when I wear it, as the mannequin was rather low and the hoop stands out a bit more towards the back on me.